4119
Waterproof Probe
This
probe is designed to be immersed in water or to be used
wherever heavy duty construction and a tubular probe
design are needed. Probe sheath diameter is 1/4 inch.
4119 Part Number Format
4119-3-100-RN-PT138W-( )-( )
Model
Number_______________________________________
4119
Sheath Length in
Inches____________________________________
3
Cable Length in
Feet_________________________________________
100
Cable Style- from Options List
_____________________________________
RN
Sensor Part Number- from Sensor Section-TC not
available _________________
PT138W or Thermistor
Options- from Options List
___________________________________________________
( )-( )
Options- should be specified in alphabetic order.
Cables- Water-blocked cable is also available for deep
water applications. Contact us.
RN
18-xSJO, rubber insulation, neoprene jacket. Number of
conductors depends on sensor type.
RNH
18-4SO, rubber insulation, heavy duty neoprene jacket.
RNS
18-4SJO, rubber insulation, braid shield, neoprene
jacket.
Connectors
In
addition to the connectors shown here, this probe can be
ordered with molded underwater connectors attached.
Because of the large variety of such connectors, we
request that you contact us to discuss your needs.
If a connector and mating connector are specified, the
one designated first in the probe part number will be
installed on the cable and the second will be supplied
loose. All mating connectors are in-line style and
include hardware.
AMP
Microphone 4 contact male (Switchcraft A4M or equal).
AMP-1
Female mates with AMP.
SP
Spade
Lugs
#8 spade lugs.
Miscellaneous Options
BL
Bent Sheath
DU Dual Sensor
PT Pointed Tip
|
A single bend, to 90°
maximum, is placed in the probe sheath. Specify
BLxx,Y with xx
indicating the distance from the probe tip to
the centerline of the bend and Y
indicating the bend angle relative to the
probe's centerline. Refer to 4150 Options and
Drawings for limitations.
Two electrically isolated sensors, in two wire
configuration, are installed in the probe
sheath. Recommended for TH
sensors only.
Sheath tip is pointed, to allow penetration into
non-rigid materials. |

Connectors
In
addition to the connectors shown here, this probe can be
ordered with molded underwater connectors attached.
Because of the large variety of such connectors, we
request that you contact us to discuss your needs. If a
connector and mating connector are specified, the one
designated first in the probe part number will be
installed on the cable and the second will be supplied
loose. All mating connectors are in-line style and
include hardware.
AMP
Microphone
4 contact male (Switchcraft A4M or equal).
AMP-1
Female mates with AMP.
SP
Spade
Lugs
#6 spade lugs.
Miscellaneous Options
DU
Dual
Sensor
Two electrically isolated sensors, in two wire
configuration, are installed in the probe tip.
Recommended for TH sensors only.
|